Prompt
Why are my encoded videos coming out too large?
Latest observation
There are a few common reasons encoded videos end up larger than expected:
1) Bitrate is set too high
This is the most common cause. Video size is mostly determined by bitrate.
- Higher bitrate = larger file
- If you’re using a constant bitrate (CBR) or a very high target bitrate, the file can easily balloon.
Rule of thumb:
file size ≈ bitrate × duration
Example:
- 10 Mbps for 10 minutes ≈ about 750 MB
- 2 Mbps for 10 minutes ≈ about 150 MB
2) Encoder quality setting is too aggressive
If you’re using a quality-based mode like:
CRFin x264/x265CQ/QP- “quality” slider in a GUI
then a lower quality number usually means larger files.
For example:
- x264 CRF 18 = very high quality, larger file
- x264 CRF 23 = smaller file, still decent quality
- x264 CRF 28 = much smaller, lower quality
3) You’re encoding at a higher resolution than the source
If you upscale from 720p to 1080p or 4K, the file can become much larger, especially if bitrate isn’t adjusted properly.
4) Frame rate is higher than needed
Encoding 30 fps to 60 fps doubles the number of frames the encoder must store, which can increase file size.
5) The codec/container isn’t efficient
Older codecs like:
- MPEG-2
- DivX/Xvid
are much less efficient than:
- H.264 (AVC)
- H.265 (HEVC)
- AV1
If you’re using an older codec, files will be larger at the same visual quality.
6) Audio settings are larger than necessary
Sometimes the video is fine, but the audio takes more space than expected.
Examples:
- Uncompressed audio
- Very high audio bitrate
- Multiple audio tracks
Try:
- AAC at 128–192 kbps for typical stereo
- Opus at 96–160 kbps
7) You may be preserving too much detail
If the source has lots of:
- grain
- noise
- motion
- complexity
the encoder needs more bits to maintain quality, resulting in larger files.
8) Two-pass / target size settings are off
If you’re aiming for a specific size but haven’t configured bitrate correctly, the encoder may not converge to the size you expect.
What to check
If you want smaller files, look at:
- bitrate
- CRF / quality slider
- resolution
- codec
- audio bitrate
- frame rate
Quick recommendations
If you’re using FFmpeg with x264, a common good starting point is:
ffmpeg -i input.mp4 -c:v libx264 -crf 23 -preset medium -c:a aac -b:a 128k output.mp4
For smaller files:
- increase CRF to 24–28
- use a slower preset if you want better compression efficiency
- consider H.265/HEVC if compatibility is okay
If you want, I can help diagnose your exact settings if you paste the command or export settings you’re using.